Estimated shipping on 06.09.24
It is important to note that the width of the blind corresponds to the measurement from the outside of one support to the outside measurement of the other support, and there will always be 5 cm less fabric. For example, if we order a 100 cm blind, the fabric size will be 95 cm.
When it comes to separating our blind from the window, it all depends on the type of support and whether it is fixed to the ceiling or the wall.
1. If we choosethe short wall bracket andstuck drop, it will have a spacing of about 2 cm.
2. If we choosewall bracket short and cascading drop, it will have a spacing of about 7 cm.
3. If we choose the long wall bracket and hanging down, it will have a spacing of about 3.3 cm.
4. If we choose the long wall bracket and cascade drop, it will have a spacing of about 11 cm.
If the blind is installed on the ceiling, it can be spaced as needed so that it does not hit any obstacles when it is lowered.
Roller blinds are made from synthetic fabrics that repel dust, especially screen and opaque fabrics. That's why we don't need to put them in the washing machine to clean them. Firstly, lower the blind until it is fully unfolded, there is no need to remove it from its supports. If it has a stain, a towel or a simple damp cloth and soap will be enough to clean it. Likewise, dust can also be removed using a vacuum or pressurized air, without scrubbing. Of course, we must not use solvents or abrasive substances that could damage the fabric coating, such as ammonia or bleach. Care should be taken with photographic blinds, as they are more delicate.
With the opaque fabric they cannot see.
The recommended option when we have an obstacle is to install it on the ceiling, but if we don't have this possibility, see the types of installation below.
1. Ceiling installation: The blind must have enough space so that it does not touch the handle.
2. Wall mounting: Two brackets are available, one short and one long. The option that most separates the blind from the window will be thelong support and a cascade drop, the fabric will be separated by 11 cm. If the handle protrudes more than this distance, we recommend placing the blind on the ceiling and giving it enough space so that when you lower the blind it does not hit the handle.
Yes, but in this case, plugs and screws suitable for plasterboard must be used. These plugs and screws can be purchased at any hardware store.
Our Cortinadecor roller blind when rolled up, they can occupy a vertical space of 7.5 cm. It is important to take this measure into account so that the blind does not hit the window when trying to open it. In a running window, we won't have this problem.
The opaque fabrics are made to not allow light to pass through. In this way, we get privacy and darkness, which makes them the best choice if we don't have blinds in the bedroom or in a screening room. The fabric does not let light through, but it can enter from the sides as the blind, panel or vertical slat is not fully adjusted as a blind can be.
An average sized blind can operate for 3 to 6 months (based on 1 up/down movement per day), before the battery needs to be recharged again. 1 up/down movement per day), before the battery needs to be recharged again.
You have a maximum of 14 channels per control unit and can control up to 16 blinds per channel.
No. Even if the battery is discharged, the entire configuration will be stored in the engine.
Your order will include:
- Product made to measure and in the chosen color.
- Brackets, screws and mechanisms.
- Motor and charger included*. Control is optional.
And it will be ready for easy installation.
* The charger is optional for the Corti 3000 Roller Blinds SmartView Motorized, Translucent Resinated Canvas Roller Blinds SmartView Motorized, and Opacos Colors Roller Blinds SmartView Motorized models.
No. You have to link the application to the blind first and then, configure the remote control through the app.
Battery charging time is approximately 4 hours.
No, it is not possible to change the engine speed.
The engine speed is 28 RPM.
In the SmartView app, go to: Settings > Blinds overview > Blinds settings. Click 'add command' and follow the step-by-step guide.
No, this is not possible. You will have to reconfigure the blind with the remote control.
No, the blinds can only be charged with their own charger.
If you have lost the QR code, don't worry. We include another code that you will find on the inside of your blind, on the back of the counterweight.
The key feature within this system is its easy operation. You can control your blind from its free mobile app and even schedule the times you want the blind to go up or down according to your needs. Additionally, you can also control it through the voice assistant Siri. Thanks to its Bluetooth operation, you don't need any electrical pre-installation to manage your blinds. You'll only need to recharge them based on usage, approximately every 4 to 6 weeks. The Opaco Colors model is perfect if you need to completely darken the room, as it's a 100% blackout fabric.
Another notable feature of this fabric is its natural appearance, as the side that would be visible from inside the room is traditional fabric, reinforcing the 'Blackout' effect on the back with a gummed finish that prevents the passage of light. This gummed finish would be of a similar tone to the chosen visible fabric. The system also consists of a reinforced 38mm tube and premium brackets with matching embellishments. Start configuring the perfect blind for your home now. Custom-made with Cortinadecor guarantee.
It is important to note that the width of the blind corresponds to the measurement from the outside of one support to the outside measurement of the other support, and there will always be 5 cm less fabric. For example, if we order a 100 cm blind, the fabric size will be 95 cm.
When it comes to separating our blind from the window, it all depends on the type of support and whether it is fixed to the ceiling or the wall.
1. If we choosethe short wall bracket andstuck drop, it will have a spacing of about 2 cm.
2. If we choosewall bracket short and cascading drop, it will have a spacing of about 7 cm.
3. If we choose the long wall bracket and hanging down, it will have a spacing of about 3.3 cm.
4. If we choose the long wall bracket and cascade drop, it will have a spacing of about 11 cm.
If the blind is installed on the ceiling, it can be spaced as needed so that it does not hit any obstacles when it is lowered.
Roller blinds are made from synthetic fabrics that repel dust, especially screen and opaque fabrics. That's why we don't need to put them in the washing machine to clean them. Firstly, lower the blind until it is fully unfolded, there is no need to remove it from its supports. If it has a stain, a towel or a simple damp cloth and soap will be enough to clean it. Likewise, dust can also be removed using a vacuum or pressurized air, without scrubbing. Of course, we must not use solvents or abrasive substances that could damage the fabric coating, such as ammonia or bleach. Care should be taken with photographic blinds, as they are more delicate.
With the opaque fabric they cannot see.
The recommended option when we have an obstacle is to install it on the ceiling, but if we don't have this possibility, see the types of installation below.
1. Ceiling installation: The blind must have enough space so that it does not touch the handle.
2. Wall mounting: Two brackets are available, one short and one long. The option that most separates the blind from the window will be thelong support and a cascade drop, the fabric will be separated by 11 cm. If the handle protrudes more than this distance, we recommend placing the blind on the ceiling and giving it enough space so that when you lower the blind it does not hit the handle.
Yes, but in this case, plugs and screws suitable for plasterboard must be used. These plugs and screws can be purchased at any hardware store.
Our Cortinadecor roller blind when rolled up, they can occupy a vertical space of 7.5 cm. It is important to take this measure into account so that the blind does not hit the window when trying to open it. In a running window, we won't have this problem.
The opaque fabrics are made to not allow light to pass through. In this way, we get privacy and darkness, which makes them the best choice if we don't have blinds in the bedroom or in a screening room. The fabric does not let light through, but it can enter from the sides as the blind, panel or vertical slat is not fully adjusted as a blind can be.
An average sized blind can operate for 3 to 6 months (based on 1 up/down movement per day), before the battery needs to be recharged again. 1 up/down movement per day), before the battery needs to be recharged again.
You have a maximum of 14 channels per control unit and can control up to 16 blinds per channel.
No. Even if the battery is discharged, the entire configuration will be stored in the engine.
Your order will include:
- Product made to measure and in the chosen color.
- Brackets, screws and mechanisms.
- Motor and charger included*. Control is optional.
And it will be ready for easy installation.
* The charger is optional for the Corti 3000 Roller Blinds SmartView Motorized, Translucent Resinated Canvas Roller Blinds SmartView Motorized, and Opacos Colors Roller Blinds SmartView Motorized models.
No. You have to link the application to the blind first and then, configure the remote control through the app.
Battery charging time is approximately 4 hours.
No, it is not possible to change the engine speed.
The engine speed is 28 RPM.
In the SmartView app, go to: Settings > Blinds overview > Blinds settings. Click 'add command' and follow the step-by-step guide.
No, this is not possible. You will have to reconfigure the blind with the remote control.
No, the blinds can only be charged with their own charger.
If you have lost the QR code, don't worry. We include another code that you will find on the inside of your blind, on the back of the counterweight.